It's Your Jeep, Only Better

TJ Upper Rear Weld-On Spring Bucket Relocation

The Jeep Wrangler TJ/LJ Weld-On Rear Coil Buckets relocate the position of the coil buckets; this helps eliminate coil buckling with lifted height springs and allow the coils to perform as it is intended.

Our Weld on brackets are built to help Jeep builders "perfect" the placement of the rear coil springs. The original equipment perch locations are not optimal for lifted applications and tend to bow longer coils when compressing. These weld on upper buckets will correct the spring geometry on your TJ or LJ Jeep Wrangler.

Note: This kit requires cutting and welding.

Note: Builder Parts are intended for your own custom application. There is no implied warranty or instructions for the use of these products; if using any of the builder parts you should be confident of your mechanical skill level and know that you will use at your own risk.

99% of 100
Availability: Usually Ships in 1 to 2 Weeks
Product Code: 7109
Dividing Line


The Original factory location for the upper rear spring buckets are welded on at an angle that does not work ideally with lifted height coil springs. Our weld on relocation brackets are complete replacements for the factory buckets and provide corrected geometry for lifted applications. 7109 Weld On Bucket

Dividing Line


Check out what Jeepers everywhere are saying about our products on The Buzz Page.
Dividing Line

Items Materials
Spring Bucket 7GA Hot Rolled Steel Plate
Bump Stop Support 2 1/2" OD X .12" Wall Steel Tube
Total Weight 8 lbs
Available in Raw? Yes
Available in Black Powdercoat? No
OEM Clevite and Typical Flex Joint is the Duroflex Joint
Installation Difficulty Moderate-Requires Welding
Body Modification Some
Time to Install 1-2 hours
OEM Clevite and Typical Flex Joint is the Duroflex Joint


This product is considered a Builder's Part. As such we do not provide the typical comprehensive instructions that MetalCloak is known for.

Please do not purchase this product unless you either have the full confidence to install this product yourself, or are prepared to have a professional do it.

If you have any questions about the difficulty of the installation of this product, please call us at 916-631-8071.

Click Here to see a full list of MetalCloak Installation Instructions.

OEM Clevite and Typical Flex Joint is the Duroflex Joint
99% of 100
Write Your Own Review
You're reviewing:TJ Upper Rear Weld-On Spring Bucket Relocation
Your Rating

(C) Copyright 2018, Armored Works, LLC - All Rights Reserved. Jeep is a trademark and service mark owned by Fiat Chrysler America. Products sold on this website are intended for Off Road Use Only.