It's Your Jeep, Only Better

Hi-Steer Kit, JK Wrangler

The MetalCloak JK Wrangler Hi-Steer kit provides a new drag-link that is placed on top of the steering knuckle and comes with a relocation bracket that raises the track bar to eliminate bump steer in your JK that is lifted over 4.5 inches.

The JK Hi-Steer Kit provides:

  • Corrected steering geometry
  • Relocation bracket raises trackbar & steering stabilizer
  • 1.375 OD Wall DOM Drag Link
  • Hi-Misalignment 1-Ton Rod Ends
  • Zerk fitting on ends for ease of service
  • Sealed with Durable rubber grease boots
  • Design limits misalignment to control Drag Link flop
  • Clears Aftermarket Diff Covers
  • Gold Zinc Chromate Coating
  • Adjustable on the vehicle
$399.00
Rating:
84% of 100
Availability: Usually Ships in 1 Week
Product Code: 7097
Dividing Line
DRAG LINK WITH GREASABLE 1-TON ROD ENDS

High misalignment rod ends, double adjustable, 1.375OD Wall DOM, and clears aftermarket diff covers.

JK Wrangler Drag Link Diagram

Dividing Line
DRAG LINK ROD ENDS
Boot Sealed - Keeps grease in and dirt out

Anti Flop Feature - Precision range of movement

Massive 1-Ton Rod Ends - Provides additional strength

JK Specific OE Bolt Taper - Secure mount

Dog Leg Tie Rod End Diagram

Dividing Line
ANTI FLOP FEATURE

Anti Flop

This specially designed rod end has been engineered just for the JK Wrangler steering.

Full side to side range of motion ensures bind free steering when pushing the extremes of your Jeeps travel and articulation, while a limited "front to back" range of movement is built into the rod-end and eliminates the possibility of the offset to allow the tie-rod to "flop".

Dividing Line
TRACKBAR & STEERING STABILIZER RELOCATION BRACKET
Raises track bar to correct steering geometry in conjunction with the Drag-link flip hi-steer for use when lifting a Jeep JK over 4.5 inches, this bracket also incorporates a raised mount for the steering stabilizer for added protection!

The durable bracket is constructed of 7GA Laser Cut CAD formed steel and is finished in Gold Zinc plating for a molecular bond that protects against the elements; relocation bracket is 100% bolt on.

Flip Kit

Dividing Line
TESTIMONIALS & BUZZ:

Check out what Jeepers everywhere are saying about our products on The Buzz Page.
Dividing Line
SHIPPING & MATERIAL SPECIFICATIONS
ItemsMaterials
Flip Bracket 7GA Hot Rolled Steel
Drag Link 1.375 OD Wall DOM
Drag Link Ends Serviceable
Length 40 1/4"
Total Weight 15 lbs
Available in Gold Zinc? Yes
OEM Clevite and Typical Flex Joint is the Duroflex Joint
INSTALLATION
Installation Difficulty Easy
Body Modification None
Time to Install 30 Minutes
OEM Clevite and Typical Flex Joint is the Duroflex Joint
Icon

INSTALLATION INSTRUCTIONS:

At MetalCloak we work continuously to give you the best possible installation instructions. We constantly take customer feedback and look at how we can make the instructions better for you. Click below to see our full list of installation instructions.

Click Here to see a full list of MetalCloak Installation Instructions.
OEM Clevite and Typical Flex Joint is the Duroflex Joint
Rating:
84% of 100
Write Your Own Review
You're reviewing:Hi-Steer Kit, JK Wrangler
Your Rating

(C) Copyright 2018, Armored Works, LLC - All Rights Reserved. Jeep is a trademark and service mark owned by Fiat Chrysler America. Products sold on this website are intended for Off Road Use Only.