It's Your Jeep, Only Better

Overline Rear Flare Mounting ExoSkin, Pair, JK, 4-Door

The JK Wrangler 4 Door Rear Flare Mounting ExoSkins provide additional strength to the vulnerable rear wheel well opening.

Designed specifically as a mounting system for Quick Release rear flares, the flare mounting hardware is built right in.

The Rear Flare Base Plate kit includes:
  • Driver & Passenger Base Plates
  • 18-8 SS Hardware Kit
  • Aluminum Flare Mounting Brackets
Note: This system comes in Raw and MetalCloak's Signature Black Powdercoat.

$369.00
Rating:
98% of 100
Availability: Raw Metal Usually Ships in 1 - 2 Weeks
Product Code: 3410*
Dividing Line
JK 4 DOOR BASE PLATES

MetalCloak's JK Wrangler Overline Front Flare options are available in narrow width 6", standard width 8", or wide width 10" MetalCloak Overlines are the original and only Removable Steel Fender allowing you to run 37's on a stock JK.

Ball Lock Joints secure each end of the Flare for incredible strength and allow them to be removed easily. Overline fenders provide the best Turning Clearance, best Object Deflection Angle and best Tire Clearance in the industry.

<<< Check Out the Video

Dividing Line

Rock-Biting Rear ExoSkin, designed to mount the Quick Release Dovetailed Flares.

11GA Cold Rolled Steel Plate creates protection and the ability to add a Rear Flare.

The weak body of the JK requires the use of the rear ExoSkin so that we can raise the Dovetailed fender and gain all that additional clearance!

Just enough tire clearance, allowing for 37's on a stock JK!

Fully integrates with the MetalCloak body armor system.

Dividing Line
OPTIONS:
Raw Metal Premium Black Textured Powdercoat
If ordered in Raw Metal, we will DA the welds and clean up the product, pack it and ship it right out to you. Our Premium Black Textured Powdercoat is the best in the industry. Powdercoated products usually ship out within two to three weeks. Check out our video on how we powdercoat.
Tube Fender Preparation
Dividing Line
SHIPPING & MATERIAL SPECIFICATIONS
ItemsMaterials
Driver & Passenger Rear Exo-Skins 11GA Cold Rolled Steel
Integrated Flare Mounting System
Total Weight 45 lbs
Available in Raw? Yes
Available in Black Powdercoat? Yes
OEM Clevite and Typical Flex Joint is the Duroflex Joint
INSTALLATION
Installation Difficulty Moderate
Body Modification Some Body Modification
Time to Install 2 - 3 Hours
OEM Clevite and Typical Flex Joint is the Duroflex Joint
Icon

INSTALLATION INSTRUCTIONS:

At MetalCloak we work continuously to give you the best possible installation instructions. We constantly take customer feedback and look at how we can make the instructions better for you. Click below to see our full list of installation instructions.

Click Here to see a full list of MetalCloak Installation Instructions.
OEM Clevite and Typical Flex Joint is the Duroflex Joint
Rating:
98% of 100
Write Your Own Review
You're reviewing:Overline Rear Flare Mounting ExoSkin, Pair, JK, 4-Door
Your Rating

(C) Copyright 2018, Armored Works, LLC - All Rights Reserved. Jeep is a trademark and service mark owned by Fiat Chrysler America. Products sold on this website are intended for Off Road Use Only.