JT Gladiator Lo Profile Modular Rear Bumper
MetalCloak's Jeep JT Gladiator Rear Bumper is a strong, Lo Profile Modular System that provides additional break-over angle without sacrificing any of the factory options.
- Increased Departure Clearance
- 7GA Steel for Superior Strength
- Rear Step Convenience
- Tow Plug Electrical Outlet
- LED License Plate Light
- Works with Factory Sensors
- Works with Factory Recovery Points
- Does Not Interfere with Tow Hitch
- Seamless Fit With "Rubicon" Bed Side Slider Protection
- Black Powder Coat Finish
- Made in the USA
The MetalCloak Bumper for the Jeep Gladiator is a perfect mix of [click for more...] function and utility. The strong 7 gauge structure is built tough and has a low profile, close fitting design that allows for increased departure clearance without skimping on utility features like an integrated step, factory recovery point accommodations, protected electrical outlet, "Rubicon" rear bedside slider fitment, and room for a tow hitch. [click for less...]
MetalCloak's Jeep Gladiator JT Bumper
Who Is MetalCloak?
MetalCloak creates Game-Changing Products for the Off Road Enthusiast.
Jeep JT Gladiator Rear Bumper
Jeep JT Gladiator rear bumper is a strong, low profile, modular system that provides additional break-over angle for your Jeep Truck without sacrificing any of the factory options.
Rear Step Convenience
The strong 7GA structure is built tough and has a low profile, close fitting design that includes an LED license Plate light above the integrated step.
Seemless Fit With Bed Side Protection
The MetalCloak Bumper for the Jeep Gladiator is a perfect mix of function and utility. Allowing a seemless fit with "Rubicon" bed side slider protection.
Tow Plug Electrical Outlet
The MetalCloak Rear Bumper isn't just strong, everything has been thought out including the ability to protect and integrate the electrical tow plug outlet.
Factory Recovery Points
MetalCloak's JT Gladiator Lo-Profile Rear Bumper does not interfere with the factory tow hitch.
Retainer Sensor Clips
- Works on 3/16" Bumpers
- Fits 1" diameter hole
- Made of UV resistant ABS
- Snaps into place
What's In The Kit?
- Rear Bumper Base
- Rear Bumper Caps
- Electrical Plug Cap
- Retainer Sensor Clips
- LED License Plate Light
- All Required Hardware
|Rear Bumper||7GA Hot Rolled Steel|
|Rear Bumper End Caps||7GA Hot Rolled Steel|
|Electrical Plug Cap||3/16" Aluminum|
|Time to Install||1- 2 Hours|
|Installation Instructions||Click Here to see a full list of MetalCloak Installation Instructions.|